This kit pumps your cock and balls together inside one extra-wide acrylic cylinder, so you build a fuller, harder, more sensitive feel in a single session. The deluxe metal hand pump pulls the vacuum and the gauge up top shows exactly how much pressure you're at.

Features

• Extra-wide cylinder seals around the shaft and balls at the same time
• Deluxe metal hand pump with a foam grip that stays put with wet or lubed hands
• Easy-read pressure gauge so you can dial in the suction and hit the same spot again
• Click-in valve holds the seal and keeps pressure after you pull the pump off
• Clear cylinder so you can watch what's happening
• 11 inches total length, 2.75 inch inner diameter
• Kit includes the cock and ball cylinder plus the metal hand pump

Materials and care

Clear acrylic cylinder with a metal pump and valve. Rinse the cylinder with warm water and a mild soap after each use, let it air dry, and store it somewhere cool and dry.

An honest note

Start at low pressure and work up slowly. This gives you a temporary fuller look and a firmer erection, not permanent size. A little water-based lube around the base helps the cylinder grab a clean seal, and you should never pump past the point where it stays comfortable. The rigid cylinder is also a bit bulky if you're packing light for travel.

FAQ

Does it fit both the cock and balls at once? Yes. The cylinder is wider than a standard shaft-only pump, so it seals around the shaft and balls together for that full, swollen feel.

How long should I pump? Keep sessions short. Build pressure slowly, hold for a few minutes, and release if anything tingles or goes numb. The gauge lets you stop at the same safe spot every time.

Will it ship discreetly? Yes. Every order goes out in plain packaging with a discreet billing descriptor, and nothing on the box says what's inside.